Page 1
Lock Identification / What Lock is Needed?
Measure lock length using the two examples shown; the vast
majority of dispensers use either an 11/16” or a 15/16” lock.
Next identify what type of cam is used on the current lock. It may
be possible to configure the existing cam to fit a new TuBAR lock.
Look at the examples below to see if the existing cam can be used:
If the existing cam is permanently
attached to the lock to be replaced,
determine the “A” lock length
dimension and the “B” cam length
dimension. A custom cam can
be configured for TuBAR to fit any
unique installation.
Installing, Using and Maintaining TuBAR®
Installing TuBAR in dispensers properly is critical for extended life
and years of trouble-free access. Install TuBAR in the up position
shown where possible. Otherwise, try to maintain a right hand or
left hand consistency throughout the installed dispensers. This is
so users easily know how to align the key for correct insertion.
TuBAR® High Security Locks are spring loaded and require
proper key orientation before operation:
k Orient key properly, insert completely, then rotate to open
k TuBAR® is not designed as a compression latch:
Unlock TuBAR® before releasing any pressurized door seal
security screws
Tighten any door seal security screws before re-locking
TuBAR®
Confirm correct lock installation and operation with regular
inspections of the application and all keys:
k Verify smooth lock operation and inspect for tampering, foreign
objects or damaged keys
k Damage caused by excessive force to lock or key may void
warranty
k Installation adjustments or modifications should be completed
by qualified installation or maintenance personnel
DO NOT use oil based lubricants (WD-40) which can attract
dirt. Introduction of any acid-based chemical will void
warranty. Use a contact cleaner, then lubricate with a Teflon
or graphite-based spray.
Crafting quality products
in America since 1903.
FUEL SECURITY SPECIFICATIONS
Lock Identification • Installing, Using and Maintaining TuBAR® in dispensers
11/16"
15/16"
Reorder #: F2644-030
864.297.6655 | compxwaterloo.net/gssp
Copyright 2013 © CompX Security Products. Any companies and/or products referred to herein
are marks or registered trademarks of their respective companies, owners and/or mark holders.
11/16"
UP
15/16"
High Security Locks.
Cam options for TuBAR® locks
Ace II Tubular
& TuBAR cam
(nothing required)
CA-1 adaptor
(required)
W-1 washer
(required)
DBA-1 adaptor
(required)
k
k
k
N. CA N. NV
OR
AK
WA
ID
MT
WY
UT
CO
NM
TX
LA
GA SC
FL
OK
MO
MI
IN
S. IL
KY
NC
VAWV
PA
NY
NJ
ME
DE
MA RICTNH
VT
W. TN E. TN
KS
NE
SD
ND
IA
AZ
S. NV
S. CA
HI
S. OH
NW. OHNE. OH
WI
N. IL
MN
WI
N. IL
MN
MS AL
AR
MD
For more information, contact
a regional sales representative
compxwaterloo.net/gssp/map